I Will Survive
Tanning Deer Hides
STEP ONE Skin the deer and bone out the tail. Scrape every particle of fat and flesh from the hide with a knife. Begin the tanning process or preserve it with a generous layer of non-iodized salt. Salted hides can be air dried until the onset of warm weather, or frozen.
STEP TWO Soak the skin in water in a plastic garbage can until it softens, changing the water often. Drain, then pull the skin back and forth across the edge of a board. Scrape it with the back edge of a knife or an old hacksaw blade with dull teeth. Do not expose the hair roots.
STEP THREE Dissolve 2 ½ pounds of salt in 4 gallons of water in the garbage can. In a plastic bucket, dissolve 1 pound of ammonia alum in a gallon of water. Slowly pour the alum solution into the garbage can, mixing thoroughly. Soak the skin for four days, occasionally stirring to make sure the hide is well coated. Rinse thoroughly with running water.
STEP FOUR Tack the hide, hair side down, to a piece of plywood. Partially dry it in a sunless place, then rub in a coat of fat liquor oil (3 ½ ounces of neat's-foot oil combined with 3 ½ ounces of warm water and 1 ounce of ammonia). Work in half of this mixture, allow it to stand for an hour, then repeat. Cover with plastic overnight.
STEP FIVE Remove the tacks, dampen the hide with a wet cloth, stretch it, then rub it back and forth over a sawhorse. Redampen it and repeat, applying additional fat liquor sparingly. When the hide is perfectly supple, smooth the surface by chafing it with fine-grit sandpaper.