ReconRobotics

tactical micro robots system

Life of the program


The Recon robotics location is in the United States. The year the group was formed in 2006. also it's a military & security program. At the university of Minnesota center for robotics for the defense and advanced research project and agency. They made about 4,000 throwable tactical bots that are manly use in 700 federal law enforcement.

Walkers of the machine.

The U.S military. Use the throw bot XT by throwing it into room's to see if there is any body. Like the police and swat they also throw it into open windows on the second floor of a building or a school. Just in case if there some one at the front door so the military or the police and swat don't break the door down and there some one there to shoot them.
Big image
Big image
Big image
Big image
Big image

Want more accessories for better handling well here it is!!!!

MOLLE is a Tactical Pack that allows the operator to carry one Recon Scout or Throwbot XT and the Operator Control Unit II or a OCU Classic. The pack features two vent holes for the OCU antennas, and corded zippers that enable a tactical operator to quickly remove either device. Each of which is attached to the pack with one MOLLE strap. The OCU can also remain attached to the pack while it is in use, enabling the operator to control the robot to see its video transmission while a second operator provides protective cover. The Pack is available in black or MultiCam.


The Bayonet Mount – Throwbot XT, or the Recon Scout XT is a simple, lightweight device that enables warfighters to see around a corner or over a wall without dropping their weapon. Or putting themselves in the line of fire. By Using the Bayonet Mount. Warfighters can attach any Throwbot to their M4 or M16 rifle,and then use it as a pole camera to gain immediate situational awareness. The Bayonet Mount will not interfere with operation of the rifle, and the robot snaps on and off in one simple motion that requires no tools.

Big image
Big image

Resources

What material is it made from.


The Throw bot XT is resistant to water and dust and the Throw bot XT weigh's about 1.2lbs and 540g. The throw bot XT has a titanium shell and cast urethane wheels and a stabilizing tail it also has a sensor and a antenna.

Wrapping it up.

U.S. forces in Iraq and Afghanistan have already been using an earlier version of the ReconScout Throw bot for a few years. It can't roll up metal wall unlike the recon scout
Big image
SWAT Team Uses Recon Scout Robot in A School
ReconRobotics Recon Scout XT training mission
Big image

Titanium

Titanium is high strength and It is highly resistant to corrosion and sea water and aqua regia also chlorine that what they make the both out of.
Big image

Urethane

They use Urethane to make the bots wheels is you don't know what Urethane is this will tell you. Urethane is capable of tremendous impact resistance even at very high durometers.

time to put up the bot.

Thanks for reading about the Throwbot XT if you want more facts I will put links at the end for more facts http://www.recon-scout.com/products/Throwbot_XT_audio.cfm http://reconrobotics.com/products/accessories.cfm.