Hero-Glas Veredelungs GmbH


Stained Glass-Cutting Diamonds On Very Rough Glass

When building French style home windows, we have to cut many gemstone formed pieces and it might be tiresome to attract around a design piece for every one. Therefore we emerged having a system for cutting them rapidly. Whenever we cut vecchio glass the task is increased due to the roughness from the glass. Should you adopt these measures when trying to chop glass into diamonds, you'll find your speed of eliminating your window is going to be considerably faster and you will have the ability to cut the rough glass effectively.

As you can tell in this photo, the glass provides extensive texture. It features a rough side, that we turn lower for that cutting, however the smooth side has seed products and bubbles in it, therefore it is tough to obtain a clean cut.

Take one gemstone pattern piece and lay it around the sheet of glass to get the glass oriented. you will want all of the pieces to operate using the texture rising and lower the peak from the gemstone, so turn the whole sheet of glass to ensure that the straight line you will be cutting lines track of the pattern piece.

In this photo, I have already cut a couple of strips and I am cutting the one that runs the size of the sheet of glass. I dip the cutter in oil and run the wheel up and lower the glass gently to spread a few of the oil at first glance that I am likely to score.

You will need to contain the glass from sliding together with your left hands while you score using the glass cutter making use of your right hands. Exert more pressure than you need to do when cutting smooth glass and then try to plow with the spots in which the cutter hits a seedy place and wishes to stop.

Then, carry the glass with hands and rock them apart to interrupt the whole strip free of the sheet of glass.

Then, slide the sheet from the strip cutter guide edge up for grabs to setup for the following strip.

Once more, I am able to utilize my hands to rock the 2 pieces apart. Many occasions I personally use running pliers when breaking strips of glass, however these are wide and also the glass is uncooperative.

This edge stop departing a bit that stays out and I must score and discontinue a little from the corner before I'm able to line the advantage from the glass facing the strip cutter guide.

When you are done, you'll have a whole stack of strips.

Go ahead and take strips, individually and eliminate diamonds. Go ahead and take pattern piece you began by helping cover their and fall into line the glass strip to ensure that you're cutting the glass in the proper position after which draw a line around the work bench utilizing a sharpie marker so that you can fall into line future strips effortlessly.

After scoring the gemstone, make use of the fringe of the strip guide like a elevated straight edge to snap the glass off.

And construct the finished diamonds in your French design window pattern. You will notice that frequently the perimeters is going to be smooth enough they will not require grinding, but make certain to grind individuals which have flaws to ensure that they will not be weak and susceptible to warmth cracking.