Anna Ramirez
The Latest News About Queue Management System
Especially important is the serial number engraved in the box. It is patient queue management system always necessary to indicate that number in all requests for assistance, spare parts, repairs or information relative to operation of the unit. The nameplate of the machine must always be read well. You may not remove or alter the data it carries. If damaged or lost, ask the manufacturer a new replacement plate. The plate is mounted on the apparatus. Recall that the guarantee is associated with the identification number of the machine. It is advisable customer queue management system to anchor the machine to the wall by means of anchors. Phoenix actually has in the back of the closet, useful to anchor to the wall and two holes in the base for attachment to the pavement Fig. Phoenix also has four adjustable feet that allow leveled also on irregular surfaces and increasing its stability.
Depending on the characteristics of the support surface adjust the height of such devices. Make sure the outlet to which you want to connect the device has adequate as required by the apparatus and which is protected by a differential circuit breaker of timely value electrical characteristics. Make the connection to the network using the planned and delivered the cable, already connected to the main switch of queue management system the machine is located in the rear of the device. The hoppers and the box cable are located in the central compartment of the machine currency exchange and are protected by a safety lock. To access the cash you need to openĀ° the central door.
Inside the box are deposited all bills inserted through the bill validate and spare change, if both hoppers were too full, and any currency which has decided to allocate only the compartment box. To remove the box unhook the side supports that link it to cabinet, acting simultaneously on the chrome handle supplied and Appendix present at the summit of the dispensing tray Fig. To re-enter the box, lift and handle the relevant appendix, place it on the bottom of the compartment and slide it towards the back of the closet into contact with the side supports of the cabinet. On reaching the position, slightly lift the box until it snaps into the forks support and push up to the stop a stop on the front surface of the hoppers. Ticket dispensing controlled by Technology LCDM device installed in the lower compartment of the change machine which can be accessed using a key supplied las opening.
https://www.youtube.com/watch?v=QUT3pOTdHgA
LCDM The device has two drawers to hold banknotes to be dispensed and a drawer of rejection which tickets are not considered suitable for dispensing are used. The drawers are supplied in the correct format for the type of ticket dispensing phase in order to purchase the coin change machine. In customer queue management system each drawer for containing the tickets, you can put stacks of a single type, so can dispense two different values. Before inserting the drawers in their respective seats, airline tighten as shown in Fig. A also stated on the back of the drawer. This lets you fit the first dispensable banknotes Figure B erratic placement of notes shown. Then check that patient queue management system tickets are made as shown in Fig. C, before entering the drawer in its seat. To modify the parameters of initial configuration of the tickets is necessary to make an adjustment to the dip switch on the rear of the dispenser. As a rule the dip switches are presented as follows. The primeros Dip Switch ON, th in OFF position, as shown in. Dip Switch refers to the bottom drawer of the second dispenser located below.