Aquamaster Plumbing make it right

Aquamaster Plumbing make it right

Aquamaster Plumbing make it right

What we have with us is a submersible sump pump, it works with the help of electricity you just need to plug in the switch board, there is the flow in the right hand side of the drum when the water level rises in the pump that make the flow also to rise and it make the switch on and as the water level goes down it shuts the pump off. So the first thing with which we have to start with is dig a hole in the concrete floor and set the sump basin down in the ground below the flush level all the water which is in your floor will leak to this sump, if necessary cut off bottom of the basin to let water in.

Before placing the sump basin into the hole don’t forget to put filter fabric under and then hold the sides and push it down below the pump will not come into the sump clogging the sump. After that put the concrete and stones below in the basin then place a flat cement block as it is been recommended by us to provide a proper flat base to the pump to set on, when the pump is on it will send the water out from the check valve which is one way valve and will not allow the water from the pipe to come along into the hole. You will be requiring a 45 degree elbow to have the turns in pipe and it will make best sump pump installation Toronto .