Dec. 19 subong
How about dec. 23, / 24th kita to Makadto.
I will treat you after and during the install !!!!!! you will measure the overall size of the marble slab. verify sz. 79.5" x 24" kung amo ni
mark the center width and ht.
Te ano na! San o.
if marble is indeed 79.5" x 24" ht. ( patricia gave me this size) . then 21 3/4 INCHES from left and 21 3/4" from right side.thisserves as your guide, that s/sheet is centered . i sent you blue masking tape
to illustrate
Charie to start gathering old old tshirt pang trapo sang metal polixh after , scissors,measuring tape, lapis
get the overall sizes again then , measure this way;
Mark, ano ladder ta ? pls. provide.
do you read it clear ?
i trial balloon anay sang marble driller, on a piece of retaso marble to make hole using the drill bit, put in the tox, the lapida laid over and screw it in with the use of the special screwdriver and bit. shld. be able to successfully remove !
CAN YOU PICTURE WHAT NEEDS TO BE DONE ?
THE SIZE OF THE STAINLESS IS 36" X 24" HT.
i ONLY HAVE 4 TAMPER PROOF SCREWS KAY KA MAHAL SINA.
i HAVE 6 PLASTICE ANCHORS
10 WASHERS
ONE DRILL BIT TO SIZE
YOU SPECIAL SCREW DRIVER AND BIT FOR THE SECU. SCREW.